Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
BLock exercise for extra coronal reduction
#1
This is the original and later versions that use less resin to print. The dimesions are the same, you can print the block holder round or flat tab version and use the solid or hollow block depending on your needs.
All have been successfully printed on a formlab and a photocentric opus resin printer.
The block holder has also worked but less effectively from FDM printing of PLA and TPU material on an S5 Ultimaker printer.
Settings for each machine were the default settings.
The .zip files contain some of the versions to date and future posts will show later versions.
DM Me for the full .stl size files if needed


Attached Files
.zip   block insert solid reduced file size.zip (Size: 1.86 MB / Downloads: 0)
.zip   block insert hollow reduced file size.zip (Size: 2.54 MB / Downloads: 1)
.zip   BLock holding wheel reduced file size.zip (Size: 5.84 MB / Downloads: 0)
.zip   Block holding wheel with flatside reduced file size.zip (Size: 3.84 MB / Downloads: 0)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)